Set up in 1999, Deland Car Accessories Co., Ltd. is a professional China precision regulator manufacturer and designer. It has years of OES and OEM precision regulators production experiences and passed ISO9000 and the TUV certification of ISO/TS16949 quality system. Therefore, we can better fulfill customers' specifications and satisfy their changing needs, such as Ford, Opel, Benz, BMW, Nissan, Toyota, Mitsubishi, Mazda, Isuzu, Hyundai, Kia and Truck series.

POWER MANAGEMENT INTEGRATED CIRCUITS. PWM CIRCUITS. *Low Dropout Voltage Regulator. *ADJUSTABLE PRECISION REGULATOR SHUNT. This three way tester allows quicker and more accurate testing of exhaust blockages in catalytic converters, mufflers, etc. Test in three different places: Oxygen Sensor adapter includes M12 and M18 thread. Flange and gasket also included for cars with flange-type oxygen sensors. To test thru the Exhaust Pipes, threaded inserts, and installing tool, sealing screws and washers are included. Testing can be done on either side of catalytic converter and muffler to pinpoint blockage. For testing through the Air Injection System four rubber adapters and quick coupler plugs are included to use at the air injection pipe inlet fitting. Special gauge has two multi-colored bands-idle and 2500 RPM, with pressures shown in PSI and bar. Hose is 6 feet, enough length for you to test from the drivers seat. Measures cylinder ability to hold compressed air.

CAP's dual-tank CO2 regulator assembly combines a precision regulator / flow gauge and an industrial solenoid valve. The unique ability to connect the REG-2 to TWO tanks of compressed CO2 allows double the run time between changing out the tanks. The flow gauge can be set from .5 to 15 SCFH. Designed to work with any 120 volt control device. Features a tank pressure gauge to indicate remaining tank pressure. Complete with 6 foot power cable and 10 foot of 1/4" air line. CO2 Generators. Carbon dioxide generators operate by burning carbonaceous fuels such as propane or natural gas. The burners used in theseCO2 generators are specially designed to maximize the production of CO2 and minimize heat as a by-product. These generators provide CO2 far more economically than any other means of enrichment. A constant burning pilot is used to ignite the gas when the generator is turned on. A thermocouple is used to monitor the pilot flame. If the pilot flame is lost, a safety valve will close so that unburned fuel will not be released into the enclosure. CO2 Generator operations may be automatically functioned according to actual ambient values when installed in conjunction with the CDMC.